Proxxon 34108 Bench Micro Mill - FF 230

Proxxon 34108 Bench Micro Mill - FF 230

The MICRO mill FF 230 is a small, accurate milling system used to mill, drill and countersink steel, cast iron, aluminum, brass and plastic. The headstock swivels through 360°, indicated on a scale. Height is adjusted via a zero adjustable hand wheel, also used as fine feed when milling. One revolution equals 1/32" (1mm) travel, 1 division equals .002" (0.05mm). The quill and headstock may be locked in position, which is essential when milling. The powerful permanent magnet motor drives via a poly-v-belt, yielding high torques, especially at lower speeds. The machine comes with three collets of 15/64", 5/16" and 25/64" (6, 8 and 10mm). The solid table has a size of 10 5/8" x 3 5/32" (270 x 80mm) and is T-slotted to 15/32" x 15/64" x 13/64" (the MICROMOT norm of 12 x 6 x 5mm).

Technical data:

Speeds

280 - 550 - 870 - 1,250 - 1,700 - 2,500rpm

Table Size

10 5/8" x 3 5/32" (270 x 80mm)

Column Size

Ø 1 3/8" x 15 3/4" long (35 x 400mm)

X-Y Travel

6 11/16" x 2 9/16" (170mm x 65mm)

Overall Height

20" (500mm)

Volts

110 - 120V AC, 60Hz

Weight

41 lb. (17kg)

Hand wheel serves as both height adjustment and fine mill feed.

Poly-V drive system offers 6 speeds between 280 and 2,500rpm.

The clamps and work piece shown are not included.

Hand wheels with zero adjustable scale, 1 rev = 1/32" (1mm), 1 division = .002" (0.05mm).

Important: For best results when milling, it is recommended to lock the headstock. This is easily done via the FF 230's lock levers.