XS Scuba X-Series HP 3442 psi

Scuba Cylinder Features

During the process of hot dip galvanizing, the exterior of our steel cylinders are submerged into 840°F molten zinc. The process deposits an 8-10 mil thick zinc barrier to protect against the corrosive ocean environment. This layer of zinc metallurgically bonds to the steel cylinder. It will not chip or wear away like painted a zinc finish.

High Pressure - 3442psi SpecificationsDescriptionX-Series 65X-Series 80X-Series 100X-Series 119ModelX7-65X7-80X7-100X8-119Service Pressure3442 psi3442 psi3442 psi3442 psiTrue Capacity66.4 cu ft81.0 cu ft99.5 cu ft123.0 cu ftBuoyancy* FULL- 8.7 lbs.- 9.0 lbs.- 10.0 lbs.- 10.9 lbs.Buoyancy* EMPTY- 3.9 lbs.- 3.0 lbs.- 2.5 lbs.- 2.0 lbs.Weight EMPTY25.1 lbs.27.7 lbs.33.0 lbs.42.0 lbs.Outside Diameter7.25 in.7.25 in.7.25 in.8.00 in.

• Manufacturing Process: Built from Chromium Molybdenum steel plate.
• Utilizes the deep drawn process; the preferred method to build a steel scuba cylinder.
• This process yields a cylinder with a very uniform wall thickness resulting in a lighter, more efficient cylinder.
• Buoyancy: These cylinders have been designed to be slightly negative at the end of a dive.
• Exterior Finish: Hot-dip galvanized - the absolute best finish for a steel scuba cylinder.
• Nitrox Ready: Cleaned and sealed at the factory.
• Free of hydrocarbons to a level of 40 mg per square meter.
• Ready for pre-blended Nitrox up to 40% FO2.
• Valves: All XS Scuba steel cylinders include the Thermo PRO valve.
• Convertible design allows for standard yoke or 230 bar DIN connections.
• Standard inlet thread (3/4"-14 NPSM) on cylinder allows upgrade to any other Thermo valve.
• These valves are clean for pre-blended Nitrox up to 40% FO2.