Simplify Your Ford 9" Axle Swap
Thinking of swapping a Ford 9" into the rear of your Jeep® Wrangler TJ or LJ but your not sure what to do about all the mounts? TNT has your solution with our 1/4" formed steel axle truss. Designed to help distribute the load put on the rear housing at any one time, TNT's Ford 9" axle truss can be ordered with the factory control arm mounts and trackbar mounting provisions. Unlike our standard rear axle truss's our 9" truss consists of a two-piece design so the third member can be easily accessed. It utilizes a mount for each side of the housing as well as two tabs that get welded to the back side of the housing. We've done this so that you can set the desired pinion angle when installing the axle yet still put the truss and mounts on at 0 degrees. To access the third member, just remove the truss by unbolting the truss from it's mounts and you'll have full access to all your third member bolts.
Please choose from the available mounts listed above. When ordered, upper control arm mounts come pre-welded to the axle truss.
All TNT axle trusses require welding to install. We strongly recommend using a certified welder for any welding tasks.
For install instructionsCLICK HERE