Handle Bar 3-Position Light and Kill Switch Combination

Featuresand Benefits

• Handle Bar Light and Kill Switch Combination
• 3-position with integrated kill
• Water proof light switch. 
• This switch clamps on to any 7/8" bar. 
• Use this switch for more control.  Switch to 'Low' to turn on lights, then switch up to 'High' to have lights plus another accessory (grip warmers, fan, more lights, etc.) 
• Many options possible. Switch is rated for 10 amps.

Wiring Instruction:

• GREEN:   ON on LOW;   OFF on HIGH  
• YELLOW:   OFF on LOW;   ON on HIGH
• BLUE:   ON on LOW;   ON on HIGH
• RED:   12V input (Power)
• WHITE:   Kill Switch Power
• BLACK:   Kill Switch Ground

HOW TO:

• Enable Kill Switch:   Remove old kill switch and simply splice to these wires. Otherwise, tap White and Black wires into the power and ground wires running between the CDI and ignition coil.
• Run lights on "Low", and lights/grip heaters on "High" Hook the light's power wire to blue. Hook light's ground wire to frame (or negative terminal on battery). Hook grip heater power wires to Yellow. Hook grip heater ground wires to frame. 
• Run grip heaters on "Low", and lights/grip heaters on "High" Hook grip heater wires to Blue. Hook grip heater ground wires to frame. Hook light's wire to Yellow. Hook light's ground wire to frame.
• Run more than one light If you wish to wire in two lights so they turn on and off together, simply Y-crimp the wires together and hook them up as described above. Use a Trail Tech Crimp Kit for a professional installation