Cousins HP2100X-A A-Arm Platform Automatic Stretch Wrapper, High Profile

MX-A HP SERIES Automatic Stretch Wrapper Features and Specifications Production Speed:  1-35 loads per hour NOTE: Process rates will vary with load size, number of wraps & forklift load/unload timeLoad Capacity:  Maximum load weight: 5,000# dynamic 12,000# static   Maximum load size: 50 W x 50 L x 80 H (71 Max.    load diagonal)Turntable:  48 Octagonal, 5/16 thick, formed steel plate   4 point caster support system   Turntable height less than 11 from floor   ANSI # 50 Direct Chain Drive c/w Chain tensioner   3-15 RPM rotational speed c/w soft start acceleration   3/4 HP DC Drive Motor   Final Revolution Deceleration and positive stop alignment   Front & back forklift ports for easy movement   Accu-Count exact turntable positioning system for    additional film savings!Film Carriage Elevator:  1/2 HP DC variable speed motor   Belt/Pulley with Anti-Fall Device   Maintenance free 12 point carriage guidance systemFilm Delivery System:  Rapid Thread 20 capacity pre-stretch film carriage   1/2 HP DC variable speed motor   Fully electronic dynamic dancer corner compensation   33 to 313% fixed stretch capability   Pre-stretch ratio variable by easy sprocket change   Rapid Thread(Safety Door) with auto power cut-off    switch   Carriage descent obstruction shut-off device for additional    safety   Side mounted film carriage for operator convenience and    safetyAutomation Features:All Electric No Pneumatics RequiredPatent Pending Cousins exclusive patent pending A-Arm cut and clamp device starts and ends the wrap process at the top of the load. This uniquely different approach to attaching and cutting the stretch film provides you with these benefits:   Selectable top banding capability   Stabilizes the load early in the wrap cycle   Places the ending film tail at the top of the load instead of    the bottom   Eliminates the need of a film clamp power source on the    turntable for easier maintenance   No air hook-ups or noisy compressors   Load placement on the turntable is not critical   There is no film clamp on the turntable that can be    damaged by debris or operator errorControl Features:  PANASONIC PLC with Touchscreen Operator Interface   Power Off On Reset Switch & Power On Indicator    Light   Single button Auto Wrap Cycle Start/Pause   Cycle Pause for applying top sheets   Reinforce wrap control for mid-wrapping   Emergency Stop Button   Turntable Jog Button   Film Carriage Lower/Raise Buttons   Film Tension (Force-to-Load) Control   Selectable Reduced Film Tension parameters for    wrapping top and/or bottom of load   Separate Film Carriage Raise & Lower Speed controls    Variable Turntable Speed Control   Triple Beam Automatic Load Height Detection sensor for    dark or shiny loads   Separate 1 to 12 Revolution Top & Bottom wrap control   Broken film/out of film detection c/w automatic machine    reset   Stack-light beacon indicates run, clear or fault   NEMA 12 Enclosure   Non-proprietary UL/CSA approved components   3 wrap modes: auto / semi-auto / top banding                     3 machines in one!Structural Features:  All structural steel construction   Forklift truck portable base structure design lifting tubes    included for front and rear access   Structural steel tube machine tower c/w sheet metal    covers   Electro-static powder coated paint finishElectrical Requirement:   115 Volts 1 Phase 60 Hz 20 Amps