WCA: Standing Bunny

Includes:  1 unfinished, rough sanded sugar pine Standing Bunny approximately 10 1/2"H x 3 1/2"W x 3 1/2" L.  This carving is from one solid piece of 16/4 sugar pine and has no lamination lines.  Photographs are representative of shape and general wood appearance.  Due to the variations of wood, each carving will be different in terms of grain patterns, color variations, and slight wood abnormalities.  Carvings will not contain open knots or extreme color variations.  (If defects within your carving is not important to you, then look at our "Wood Carvings: Sale" section to see if the carving that you are looking for is available at a reduced price.) Carvings are packaged in a plastic bag in order to maintain a somewhat stable temperature environment.  Keep product in plastic bag until ready to use.  Do not store product in front of a heater, in the sun, or in windy environments as checking and delaminating will occur.  When possible, always apply a finish to your project as soon as possible.  Always refer to the preparation and finishing instructions on any finishes that are used.  SOURCEnterprises, Inc. will not accept any retuns of products on which a finish has been applied.  The purchaser or user of this carving is responsible for testing and verifying whether the product purchased is suitable for the intended use.  The purchaser or user assumes all risk and liability.  SOURCEnterprises, Inc. has the sole obligation to replace or issue a credit for defective product.  SOURCEnterprises, Inc. shall not be liable for any loss or damage from the use of inability to use the purchased product.  Supporting Our Families - MADE IN USA