UPR ABS Boostmaster Supercharger Intake Pipe for 86-95 Mustangs

This incredible New 4" Boostmaster pipe is made from a high strength ABS to keep the air super cool for the maximum performance benefits and clean installation. UPR's exclusive ABS design will add up to 40hp on the following Supercharged applications, 1987 to 1995 Mustangs equipped with a Vortech, Paxton or Powerdyne supercharger system. This system will yeild the best price and performance against any other kit available without question ! The New ABS UPR Boostmaster pipe was developed because of the need for an affordable Supercharger intake pipe that would outperform all the competitors pipes by having the densest and coolest air intake charge ever. This new design is the ( only ) supercharger pipe that will give you a true cold air stream. There is no messy welds or splatter or slag and a need for additional coatings to prevent rust or damage from the environment. The UPR Boostmaster, with its superior construction, is the highest flowing intake pipe for the any supercharged application available. Our design requires the mass air to be mounted in the inner fender for the coolest air charge. The results from our new revolutionary new ABS design as tested on a 1993 GT with a Vortech S-Trim and a 1992 LX with a Paxton NOVI 2000 were Incredible ! The two cars went as follows: 93 GT gained 5lbs. of Boost from 9lbs. of boost to 14lbs. and went 2.5 tenths quicker and gained 4.6 mph at the track. 92 LX gained 4lbs. of Boost from 13lbs. of boost to 17lbs. of boost and went 2.3 tenths quicker and gained 4 mph at the track, both cars gained between 35hp to 40hp. Application: 1986-1995 Mustang 5.0 w/Paxton, Vortech or Powerdyne Superchargers