|
|
|
SafePassage AIS 100 Dual-band AIS Receiver USB connectivity Serial connectivity Seamless interface with other hardware Compact and cost-effective, the 100 is the simplest way to add AIS collision avoidance capability to an existing navigation system. Full product specifications for the 100 Lightweight, compact design Fast, easy USB connectivityLow 1.2 watt power consumption Receives data from as far away as 30 nautical milesDual frequency: AIS1 161.975 MHz and AIS2 162.025 MHz simultaneously monitored25 kHz bandwidthBaud rate 38400 bpsEMC certified EN61000-6-3:2001, EN61000-6-1:2001, IEC 60945Receives all AIS VDL messages simultaneously on both channelsUses industry standard IEC 61162-2/NMEA 0183 message protocolOperating temperature ranges from 5 to 131 degrees FahrenheitSensitivity to 107 dBmGMSK demodulation70 dB adjacent channel rejectionSafePassageAIS is PC- and Mac-compatibleSafePassageAIS comes with a serial cable for chart plotter and radar connectivityAIS 100 installation instructions The SafePassageAIS 100 can be installed in three easy steps. 1. Mount your AIS antenna (purchased separately). 2. Load the USB driver.3. Install the SafePassageAIS near your computer, chart plotter or radar. Connect the USB cable to your computer or the serial cable to your chart plotter or radar. There's no need to run a separate power line if you use the USB connector since power is supplied to SafePassage through the USB port. If you use the serial connector you need to power the SafePassage with 12V DC.NOTE: In the event that your vessel's 12V power supply or your inverter fails, your laptop's battery will act as an Uninterruptible Power Supply (UPS) for both your navigation system and SeaCAS SafePassage.
|
|
|
|
|
|
|
|
