|
|
|
SafePassage AIS 300 Dual-band AIS Receiver GPS USB connectivity Serial connectivity Integrated AIS and GPS with 10-meter antenna cable Seamless interface with other hardware See below for full product specificationsThe 300 is ideal for anyone who wants to add a sophisticated AIS collision avoidance system and GPS to their PC- or Mac-based navigation software. Full product specifications for the 300 Lightweight, compact design Fast, easy USB connectivityRugged and waterproof fiberglass tube resistant to saltwater and vibration per IEC 60945Low 1.2 watt power consumption Receives data from as far away as 30 nautical miles16-channel GPS, WAAS and EGNOS enabledDual frequency: AIS1 161.975 MHz and AIS2 162.025 MHz simultaneously monitored25 kHz bandwidthBaud rate 38400 bps EMC certified EN61000-6-3:2001, EN61000-6-1:2001, IEC 60945Receives all AIS VDL messages simultaneously on both channelsUses industry standard IEC 61162-2/NMEA 0183 message protocol10-meter antenna cable (maximum cable length of 30 meters is available)Operating temperature ranges from 5 to 131 degrees FahrenheitSensitivity to 107 dBmGMSK demodulation70 dB adjacent channel rejectionSafePassageAIS is PC- and Mac-compatibleSafePassageAIS comes with a serial cable for chart plotter and radar connectivity AIS 300 installation instructions The SafePassageAIS 300 can be installed in three easy steps. 1. Mount the single unit AIS receiver to any standard marine antenna mount (antenna mount not included). 2. Load the USB driver. 3. Install the Signal Converter near your computer, radar or chart plotter. Connect the USB cable to your computer or connect the serial cable to your chart plotter or radar. There's no need to run a separate power line if you use the USB connector since power is supplied to SafePassage through the USB port. If you use the serial connector you need to power the SafePassage with 12V DC. NOTE: In the event that your vessel's 12V power supply or your inverter fails, your laptop's battery will act as an Uninterruptible Power Supply (UPS) for both your navigation system and SeaCAS SafePassage.
|
|
|
|
|
|
|
|
