|
|
|
The Switlik CLR6 Life Raft provides two separate chambers within the buoyancy tube by using two internal sleeves, which are each closed at one end. The open ends are attached to the inside of the buoyancy tube at the same position where bulkheads would normally be found. Upon inflation of the life raft, these internal sleeves lie flat and uninflated on the bottom of the raft buoyancy tube, because air pressure throughout the entire interior of the buoyancy tube is equal.Standard Features & AccessoriesSOLAS retro-reflective tapeSea anchor (secured on raft tube)Heaving ring and line (on raft tube)Safety knife (on raft tube)SOLAS locator lightBoarding ladder50' Mooring lineBallast pockets, large volume (4)Urethane coated nylon buoyancy chambersIntl. orange hi-visibility canopy with blue liningFurlable canopy top Furled canopy sides (2)Hi-load strength attachment pointsCO2 inflation system (located on raft side)Exterior life linesInterior grasp linesCanopy furling tiesCanopy zipperRaft righting strapOver-pressure relief valves (4)Canopy support arches (2)Topping off valves (4) USCG/ORC Equipment PackBuoyancy chamber repair kit.Bailer.2 Sponges.2 Paddles.1 Waterproof flashlight.3 Spare batteries and 1 bulb. 3 USCG Approved Day/Night flares.6 Anti-seasickness tablets per person (36). Survival/raft use instructions. 50' 500 lb. test utility line. Whistle. Signaling mirror. Optional Features"INFAB" independent inflatable floor.Abrasion resistant urethane coatednylon raft valise or hand laid fiberglasscontainer.Deck mounting cradle. Hydrostatic release.EPIRB.Watermaker.
|
|
|
|
|
|
|
|