|
|
|
WATERPROOF ANALOGBLASTER'S GALVANOMETERMSHA APPROVAL #: 2G-3479-0THIS UNIT IS BLACK WITH ALL BLACK HARDWARE WHICH WAS INTENDEDFOR USE BY LAW ENFORCEMENT. THIS IS THE ONLY DIFFERENCEBETWEEN THE L-DRC AND THE SCORPION W-DRCMechanical:Case Material: H.D. Urethane Case Size: 3"W x 1.5"D x 4"H 7.6cm W x 3.81cm D x 10.13cm H Weight: 9.8 oz. (0.278 kg) Shipping Weight: 1 lb. (0.454 kg) Electrical:Power Source: 1 Ea. "Lawrence" SILVER CHLORIDE DRY CELL (AgCl) Battery Voltage: 0.9V Meter Range: 0 through 160 OHMS Marked Divisions: 0 to 25 Operating Manual:SCORPION L-DRCANALOG BLASTER'S GALVANOMETERMSHA Approval#: 2G-3479-0Section I - MechanicalCase Material: Heavy Duty UrethaneCase Size: 3"W x 1.5"D x 4"H (7.6cm W x 3.81cm D x 10.13cm H)Weight: 9.8 oz. (0.278 kg)Type Circuitry: AnalogPower Source: 1 Ea. 0.9V AgCl Silver Chloride Dry CellSection II - Operating ProceduresTo test blasting circuit; simply touch to and hold both ends of circuit tothe contacts located on top of the unit and take resistance reading fromface of unit.Should the unit fail to measure replace Silver Chloride Dry Cell located under the waterproof battery cap on the right side of the machine. Takenote of and assure that polarity is correct when replacing the cell.Do Not allow the contacts to become dead shorted for any extended period oftime against a conductive material as this will drain the Silver ChlorideDry Cell and could provide temporarily high readings.Section III - Handling & CareTo maintain the proper functionality of your Scorpion L-DRC Blaster's Galvanometerplease observe the following: a. Avoid severe impact. The L-DRC is impact resistant however severe localized or blunt impact could crack and/or breach the L-DRC's casing rendering the unit no longer waterproof. or functional. b. NEVER use your L-DRC as a lever or impact device. c. NEVER use your L-DRC to test current. The W-DRC is for measuring electrical resistance ONLY. d. NEVER USE OR ACCEPT READINGS FROM A DAMAGED OR QUESTIONABLE MACHINE. For repair and servicing see Section V - Servicing.Section IV - LabelingThe L-DRC's face plate includes operating instructions, the unit'sserial number and MSHA Approval status. Should these labels becomeunlegible or are removed see Section V - Servicing for replacement.
|
|
|
|
|
|
|
|
